MANOY® Sliding Ring

Type 305

MANOY® Sliding Ring

Type 316

MANOY® Sliding Ring

Type 327

TECHNICAL DATAS

inner sealing inner sealing inner sealing
Motion Motion Motion
linear, partially static linear, partially static linear, partially static
Direction of pressure Direction of pressure Direction of pressure
unidirectional, bidirectional unidirectional bidirectional
Operating pressure (MPa) Operating pressure (MPa) Operating pressure (MPa)
30 30 30
Linear speed (m/s) Linear speed (m/s) Linear speed (m/s)
5 5 5
Diameter range (mm) Diameter range (mm) Diameter range (mm)
3 to 3000 3 to 3000 3 to 3000
Housing Housing Housing
non-split
(from 25 mm Ø)
non-split
(from 25 mm Ø)
non-split
(from 25 mm Ø)
Type 305 inner sealing
Motion linear, partially static
Direction of pressure unidirectional, bidirectional
Operating pressure (MPa) 30
Linear speed (m/s) 5
Diameter range (mm) 3 to 3000
Housing non-split
(from 25 mm Ø)
Type 316 inner sealing
Motion linear, partially static
Direction of pressure unidirectional
Operating pressure (MPa) 30
Linear speed (m/s) 5
Diameter range (mm) 3 to 3000
Housing non-split
(from 25 mm Ø)
Type 327 inner sealing
Motion linear, partially static
Direction of pressure bidirectional
Operating pressure (MPa) 30
Linear speed (m/s) 5
Diameter range (mm) 3 to 3000
Housing non-split
(from 25 mm Ø)

APPLICATIONS

  • The­se inner sealing sli­ding rings are the solu­ti­on for designs which only allow a small or low housing
  • They are ide­al for retro­fit­ting into exis­ting O‑ring groo­ves

CHARACTERISTICS

  • Wide ran­ges for pres­su­re, speed, tem­pe­ra­tu­re and fluids 
  • Low bre­a­ka­way tor­que – even after long shut­down 
  • Very long life due to high abra­si­on resis­tan­ce 
  • Dry run­ning capa­bi­li­ty
  • Resistant to pres­su­re peaks and die­sel effect
  • Except for small dia­me­ters, can be instal­led in non-split groo­ves
  • Free choice of dia­me­ter bet­ween 8 and 3,000 mm

TEMPERATURE RANGE

From ‑54 to +200 °C (tem­pora­ri­ly +260 °C)

but depen­dent on the sli­ding ring and O‑ring mate­ri­al in each case.

MATERIALS

IDG sli­ding ring mate­ri­al

  • 91B (pneu­ma­tics)
  • 62A (water hydrau­lics)
  • H12

O‑ring elas­to­mer

  • NBR
  • FKM (hig­her chemical/temperature resis­tan­ce)
  • EPDM (steam envi­ron­ments)

Mate­ri­al descrip­ti­on and other mate­ri­als for wider app­li­ca­ti­ons FIND OUT MORE >